青青久久av北条麻妃黑人,国产伦理精品,国产精品爽爽爽爽爽爽在线观看,精品国产乱码久久久久久虫虫漫画

無錫五金廠地坪價格是多少 400-0709-910(請撥打400-0709-910電話，永堅地坪公司)

Whether the cement floor or tile floor, we have to be polished, and for the depth of the tile floor must be polished, tiled floor because the material itself is relatively compact, not easily penetrate and bonding, only the fine sanding rough ground, in order to enhance floor paint and bonding effect the ground. And with respect to the requirements of flatness to the ground to have to wear a floor tile spacing gap must be addressed. This off relatively time consuming, but is a very important part.

    2. The epoxy floor paint primer construction

    Because epoxy floor paint primer play a connecting role in floor paint coatings, the construction must be adequate, even to enhance the wear-resistant flooring epoxy primer strength and abrasion resistance, in order to avoid from the shell, delamination and other phenomena.

    3. epoxy floor paint mortar layer must be thicker handle

    The epoxy floor paint finish construction

    In epoxy floor paint finish construction of this ring, you can roll coating according to the actual needs of customers use, brushing, coating, etc. for construction eels, in order to achieve different effects. Underground parking entrance slope was relatively large, and therefore a high slip resistance requirements on the ground. Stop underground garage floor construction landslide genuine difficult, mainly comprises seven steps, concrete construction method is as follows:

    1, clean up, clean the base surface

    Wash with water cannons ground, clear the ground of oil and other impurities, if potholes, holes, also handle.

    2, primer construction

    Overall spray penetration primer material into the concrete and closing the pores of the concrete floor solid integration.

    3, compressive layer construction

    After the primer dried, Scraping slip compressive layer, in the vast majority of ramp-slip floor project, compressive layer is yellow slip compressive material, this layer will be partial nudity, As part of the ramp line.

    4, marking and paste Masking

    On the ground mark the auxiliary grid lines, planned無論對于水泥地面或是瓷磚地面，我們必須進行打磨，而對于瓷磚地面必須進行深度打磨，因瓷磚地面材質本身相對致密，不容易滲透和粘接，只有把地面打磨精糙，才能增強地坪漆與地面的粘接效果。而相對于對于地面要求平整度高，以須耐磨的地面，必須解決瓷磚間隔的縫隙。這一關相對耗時，但又是非常重要的一環。

2.環氧樹脂地坪漆底涂施工

因環氧樹脂地坪漆底漆在地坪漆的涂層中起到承上啟下的作用，施工必須足量，均勻，以增強環氧樹脂耐磨地坪底漆的強度以及耐磨性，以避免起殼，脫層等現象的發生。

3.環氧樹脂地坪漆砂漿層必須進行加厚處理

4.環氧地坪漆面漆施工

在環氧樹脂地坪漆面漆施工這一環，可以根據客戶的實際需求采用輥涂，刷涂，饅涂等方式進行施工，以達到不同的效果。地下停車場出入口坡度都比較大，因此對地面的防滑性要求很高。地下車庫止滑坡道地坪施工難度比較大，主要包含7個步驟，具體施工方法如下：

1、清理、清潔基面

用高壓水槍清洗地面，**地面油污和其它雜質，如果有坑洼、孔洞等也要處理好。

2、底涂施工

整體噴灑滲透底涂材料，滲入混凝土并封閉毛孔，使混凝土地面牢固整合。

3、抗壓層施工

待底涂干燥后，批刮止滑抗壓層，在絕大多數的坡道止滑地坪工程中，抗壓層用的都是黃色止滑抗壓材料，這一層將會部分裸露，作為坡道線部分。

4、劃線并貼美紋紙

在地面上劃好輔助網格線，規劃好

資訊來源：<聯系電話:400-0709-910>