|
國標的托盤高度一般在100mm，所以國標的手動液壓搬運車**高度當然在這之下。一般的液壓搬運車放到**點的時候高度是85mm、75mm兩種，當然也有特殊的低放型手動液壓搬運車，**高度甚至能達到35mm。低放車一般價格稍貴，沒有特殊需求不建議采購。而且低放到35mm的手動搬運車鋼板相對來說比較薄，所以載重最多只有1.5噸。
Lift height
GB tray height is generally at 100mm, so the national standard of manual hydraulic trucks minimum height, of course, under this. The general hydraulic pressure truck to the lowest point, height is 85mm, 75mm two, of course, there are special low release manual hydraulic carrier, the minimum height can even reach 35mm. The price of a low - lift truck is a little expensive, and there is no special requirement. And the manual pallet truck with low 35mm is relatively thin, so the load is only 1.5 tons at most.
三月，醉一場青春的流年。人生的三月，我們正值青春，風華正茂。在這樣一個充滿活力的年紀，我們要把握機遇，朝人生的**沖刺；我們要珍惜每一個讓我們流連忘返的風景，保持年青的心態(tài)，隨時準備著與時間賽跑；我們要在時光深處，保持一種淡然而灑脫，矜持而深情的微笑，讓三月的風景陪我們笑語盈盈，清芬一路。
手動液壓車輪子材料要根據(jù)作業(yè)地面的狀況來選擇。地面狀況平滑的可以選擇尼龍輪子，因為尼龍的輪子相對比較便宜，而且拉著也比較省力。地面狀況不好的，可以選擇鋁合金加聚氨酯的輪子，它們比較耐磨。如果不想太傷地面，比如工廠有些是地坪的地面，**不要用尼龍的輪子，應該選用聚氨酯的。因為尼龍的太硬了，聚氨酯相對來說比較軟一點。
Wheel material
Manual hydraulic car wheel material according to the situation of the ground to choose. The ground condition is smooth, you can choose nylon wheel, because nylon wheel is relatively cheap, and pulling is also more labor-saving. The ground condition is bad, you can choose aluminum alloy plus polyurethane wheels, they are more wear-resistant. If you do not want to hurt the ground too, such as factories, some ground floor, it is best not to use nylon wheels, polyurethane should be used. Because nylon is too hard, polyurethane is a little softer. |
您當前的位置: 首頁 > 行業(yè)供求信息 > 信息展示
